6
FTF01 Rev.3.1 01/2021
Luxier
Installation
6. Hold the Tub Filler Assembly in place and
install the four Mounting Screws. Check
alignment and level before fully tightening the
screws. After tightening the screws slide the
Escutcheon down to cover the flange.
7. Connect the Hand Shower Hose (5) to the
Tub Filler with the hex nut end to the Tub Filler.
(
NOTE:
Make sure the rubber washers (1) are
installed on both end of the hose)
Hand tighten the Hand Shower Wand (6) to the
Hand Shower Hose (5). The Hand Shower Wand
should be placed in the Holder (3) when not in
use.
Remove the aerator assembly (2) from the
spout and turn on water for 1 minute and check
for leaks at all connections. Move the Handle
(4) throughout the temperature range to flush
out any debris in both hot and cold water lines
thoroughly. The installation is now complete.
6
Hex Fitting
1
5
2
3
4
1
6
7
