English
OCEANO 35/40/50/60
Operating and service manual
pag.
42 di 116
REPLACING CHANGING MACHINE PARTS
Changing machine parts, if necessary, must be
carried out only by authorized personnel, and in
any case you should refer to your dealer.
CLEANING AND DAILY CHECKS
At the end of the working day, the machine must
be cleaned according to the following procedure:
1)
Switch off the main switch (
1
).
2)
Remove the overflow pipe (
a
) and make sure
that all the water in the machine is drained
away.
3)
Clean the filter (
b
) and remove any residue
from the bottom of the tank.
25 - CHANGING PARTS - CLEANING
4)
Make sure the washing and rinsing nozzles are
not clogged up by dirt. If necessary, clean them
up with a pin (or other) or, if possible, with com
pressed air.
5)
Wash and take any grease off inside and
outside the machine with a sponge soaked in
water and detergent.
To clean any accessory (for example the drain
pump) refer to the accessories instructions.
At the end of every working day the water tap
must be closed and the main switch deactivated.
a
b
b
1
WARNING: The use of scourers or common steel brushes to clean stainless steel is
to be absolutely avoided as iron particles can be left behind, oxidize and
produce rust. Also the use of acid or any corrosive product is to be avoided.
Please check carefully the label on the bottle.
WARNING: Do not wash the machine with direct or high pressure water jets: if water
gets reaching the electrical connections could jeopardize the correct working of the
machine and of its safety systems.
WARNING: If the machine is not being used, it is advisable to keep the cover open to
avoid bad smells.
Summary of Contents for Oceano 35
