English
OCEANO 35/40/50/60
Operating and service manual
pag.
28 di 116
4 - SAFETY DEVICES
The machine is equipped with the following
safety devices:
1)
Thermal cutout for pump protection.
2)
Safety thermostat.
3)
Microdoor (
a
).
5 - MACHINE NOISE
The continuous, equivalent, weighted acustic radiation pressure level A for the operator, working in front,
is
lower than 70 dB
.
Measurements were made at a distance of 1 m from the machine and a height of 1.60 m above ground.
6 - ELECTRICAL SYSTEM COMPLIANCE
The machine electrics comply with
UNI EN 60204/1 and CEI 44/5
regulations.
To use the kiln better, respect the following instructions:
• Install the machine in compliance with the instructions found in the paragraph “Installation”.
• Install the machine in an area out of reach of the personnel not authorised to operate it and
especially out of thereach of minors.
• Use the machine with great care and never be distracted.
• Do not wear ample clothing or clothing with wide and open sleeves.
• Do not let anyone approach it during use.
• Do not remove, cover or modify the identification plates placed on the machine body.
• Do not remove the protections and do not modify or bypass the mechanical and electrical protection
devices.
• Work on the products permitted only and not on other types.
• Do not use the machine as a working top and do not place any objects on it that do not pertain to the
normal working operations.
• Do not use the machine with electrical connections of the temporary type, with temporary or
non- insulated cables.
• Periodically check the state of the power cable and the cable clamp on the machine body, replace it
as soon as is necessary and have it done by qualified personnel.
• Stop the machine immediately as soon as there is defective, or abnormal operation, a breakage is
suspected, there are incorrect movements, unusual noises.
• Before cleaning or carrying out maintenance, disconnect the machine from the electricity mains.
• Use protection working gloves for cleaning and maintenance.
• For all extraordinary maintenance consult the manufacturer or qualified or authorised personnel.
• Do not aim high-pressure jets of water at the kiln.
• When sharp accessories are manipulated, use cut-resistant gloves.
a
Summary of Contents for Oceano 35
