Product Name:
Peacock and Pot Polyresin Fountain with LED Lights
SKU #:
WHF548
Contact: [email protected]
Instruction Manual
Please save this manual for future reference.
•
Before connecting to the power source, make sure that the pump is assembled and completely submerged
in water.
•
Always disconnect the pump from the power source before performing any maintenance on the pump,
lights (if equipped), or fountain.
•
Do not exceed the voltage shown on the pump.
•
Check the water level regularly to ensure the pump is completely submerged during operation. The pump
should be fully submerged during operation. Do not add water while operating the product. Always
disconnect the pump from the power source before adding water.
MAINTENANCE OF YOUR FOUNTAIN:
•
Keep water clean
-
using clean water will reduce mineral deposits and improve water clarity.
•
Clean the fountain periodically to prevent mineral deposits and contamination. Use warm soapy water and a
stiff brush for heavily stained surfaces.
Do not use harsh chemicals as this will damage the finished surface
and void the warranty.
•
Add clean water periodically to ensure that the pump is fully submersed in water.
•
Disconnect the power and empty the basin if the fountain will not be used for an extended time.
•
If installed outdoors and in a freeze-area of the country, ensure that all water is removed and the unit is
completely dry.
This product is NOT to be operated below 41
℉
(5
℃
) freeze damage may occur.
WARNINGS:
1.
To reduce the risk of electric shock, connect only to a properly grounded, grounding type receptacle.
2.
To reduce the risk of electric shock, use only on portable self-contained fountains no larger than 5 feet in
any dimension.
3.
Do not exceed the voltage shown on the pump.
4.
Always disconnect the pump from the power source prior to beginning any maintenance or work on the
pump or fountain.
5.
Inspect the power cord for damage before installation and/or maintenance. Replace the entire pump if
damage is found.
6.
For pumps with a 3-prong, grounded type plug, do not remove the grounding pin from the plug on the
power cord.
