Luxair LA 90 DOWNDRAFT BLK, Installation Manual

Page: 17 / 20

18
compliance with current regulations and positioned in an accessible area, after installation.
If it not fitted with a plug (direct mains connection) or if the plug is not located in an acces-
sible area, after installation, apply a double pole switch in accordance with standards which
assures the complete disconnection of the mains under conditions relating to over-current
category III, in accordance with installation instructions.
Warning! Before re-connecting the hood circuit to the mains supply and checking the efficient
function, always check that the mains cable is correctly assembled.
The hood is provided with a special power cable ; if the cable is damaged, request a new
one from Technical Service.
Mounting
Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However,
a qualified technician must verify suitability of the materials in accordance with the type of
wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Do not
tile, grout or silicone this appliance to the wall. Surface mounting only.
Operation
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended
that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes approximately after terminating cooking.
1. On/Off Light
2. Opening/ First gear
Short press
Hood closed - pulling out process begins (light is blinking)
- Hood is working (height lower than minimum) – Closing process begins (opposite situ-
ation)
- Hood is working (height higher than minimum) – Hood stops
Hood at the minimum height – first gear automatically turned on
Hood at minimum height – motor turned off
Long press
Forced opening process
1 2 3 4 5