17 |
P a g e
ATTACH THE INSTALLATION BRACKETS
Bracket spacing is the same for both inside and outside mounts. Two installation
brackets are positioned on mounting surface so that their centrelines will be
located 50mm from the ends of the headrail. If more than two brackets are
required, additional brackets are spaced evenly between them. Measure and
mark all bracket centrelines on the mounting surface.
On the headrail of shadings over 915mm wide, the centrelines of the limit stops
should be located 140mm from the ends of the headrail. On shadings 915mm or
less in width, the limit stops should be located near the centre of the headrail.
Should an obstruction prevent the end installation brackets from
being mounted at the 50mm location, the brackets can be
moved further from the ends of the headrail, to a maximum
distance of 125mm. If the final location of the bracket
centrelines is 100mm or more from the ends of the headrail, the
limit stops must be moved. Reposition the limit stops so that their
centrelines are 50mm from the ends of the headrail. The
installation bracket has a tab on the bottom to prevent the
fabric from snagging on the bracket. Do not break off the tab
unless it interferes with bracket attachment. To remove the tab,
simply twist it off with your fingers.
INSIDE MOUNT APPLICATIONS
To inside mount a Silhouette Shading, attach the tops of the installation brackets
to the top sill of the window opening. The flat surface of the sill must be at least
22mm deep. To fully recess the headrail assembly, the flat surface must be at
least 73mm deep. Add to these minimum depth requirements the dimension of
any obstruction to the bottom rail, such as a window crank or handle.
Two screws are used to attach each bracket. Position the brackets on the
centrelines you marked and then attach them with the appropriate fasteners. Be
sure their front edges are aligned
