Lux Tools A-FMR-20 Set, Original Instructions Manual

Page: 25 / 100

GB
25
The vibration values specified in the technical data
represent the main uses of the device. The actual
existing vibrations during use may deviate from these
as a result of the following factors:
• Incorrect use of the product;
•
Unsuitable tools inserted;
• Unsuitable material;
•
Insufficient maintenance.
You can reduce the risks considerably by following
the tips below:
– Maintain the device in accordance with the
instructions in the operating instructions.
– Avoid working at low temperatures.
– When it is cold, make sure your body and your
hands, in particular, are kept warm.
– Take regular breaks and move your hands at the
same time to promote circulation.
Personal protective clothing
An overview of your unit
►
P. 3, item 1
1. Stirrer basket
2. Mixer shaft
3. Tool receiving socket
4. Revolution regulator
5. Handle
6. Switch lock
7. On/Off switch
8. Battery pack
Battery pack
►
P. 3, item 2
9. Display for remaining capacity
10. Button for remaining capacity
11. Locking button
Battery charger
►
P. 3, item 3
12. Control light
Scope of delivery
• Paint and cement stirrer
•
Mixing paddle
• Mixer shaft
•
Battery charger
• Battery pack
• Operating instructions
Installation
Mounting the stirrer basket
– Screw the mixing shaft (2) to the tool holder (3).
– Counter hold the tool holder using a 17 AF open-
ended spanner and tighten the mixing shaft using
a 22 AF open-ended spanner.
– Screw the mixing paddle (1) to the mixing
shaft (2).
Using for the first time
Charging the battery pack
The battery pack must be charged prior to the first
start-up (charging time:
►
Technical data – p. 27 ).
►
P. 4, item 4
– Press in the locking button (11) and remove the
battery from the device.
►
P. 4, item 5
– Insert the battery pack into the charger.
– Plug the charger into the power supply.
The charging status is displayed by the control
light (12).
Checking the remaining capacity of the battery
– Press the button (10).
The remaining capacity of the battery is displayed by
the control lights on the display (9).
Operation
Check to make sure the device is in a safe operating
condition:
– Check to make sure there are no visible defects.
– Check to make sure all device components are
correctly mounted.
There are risks caused by spraying of the
substance you are mixing! Wear goggles.
When working with dusty substances, wear
a dust protection mask.
When machine parts rotate, do not wear
gloves.
Note: The actual appearance of your prod-
uct may differ from the illustrations.
DANGER! Risk of injury if switched on
accidentally!
Pull out the power plug before
conducting any work on the device.
WARNING! Risk of injury! Comply with all
safety instructions when handling recharge-
able devices.
NOTICE! Risk of damage to the unit! Do
not allow the battery pack to deep discharge.
Note: If the battery is fully loaded, the
charger automatically switches over to the
maintenance charge function. The battery
can thus remain in the charger permanently.
DANGER! Risk of injury! The device may
only be put into operation if there are no
defects. If a part is defective, it must be
replaced before the device is used again.
WARNING! Risk of injury! The unit may
only be used with the additional handle
mounted.