will be 5F (3C) degrees lower than the current set temp. For Cool mode, the
set temperature used will be 5F (3C) degrees higher than the current set
temp.
NOTE: The Setback settings need to be performed in a timely manner, as the
thermostat will timeout and automatically exit these adjustment screens after
approximately 10 seconds without a button press.
TO START A SETBACK: Press the MENU button, then press the SCROLL
button until “TEMPERATURE SETBACK” is shown, then press the OK button.
The words “OVERRIDE LEFT” will appear at the top of the screen, along with
two digits and the word “HRS”. Use the UP and DOWN buttons to set the
duration for how long you would like to maintain a fixed set temperature
(from 1 to 12 hours). If you would like to set the duration for longer than 12
hours, keep pressing the UP button. The display will change from “HRS” left
to “DAYS” left, with an available duration of 1 to 30 days. Once you have
selected your desired Setback duration, press the NEXT button to advance.
The display will change from “OVERRIDE LEFT” left to “OVERRIDE
TEMPERATURE”. Use the UP and DOWN buttons to select your desired Set
Temperature that will be used during the Setback duration. Once complete,
press the NEXT button to accept the setting and return to the Normal Run
screen.
TO CANCEL A SETBACK: A Setback can be cancelled by either pressing the
HOLD button two times, or by moving the mode switch to OFF, pausing
briefly, then switching back to the HEAT or COOL position. When in the
Normal Run mode, the display should say either “HEAT MODE” or “COOL
MODE”.
TEMPERATURE LIMIT STOPS:
There are two independent set temperature
limit stops: a maximum heat set temperature, and a minimum cool set
temperature. These stops do not prevent a user from performing normal
actions like Temperature Override or Hold. The Heat Limit Stop prevents the
set temperature from being adjusted higher than the heat limit setting. The
Cool Limit Stop prevents the set temperature from being adjusted lower than
the cool limit setting. Each of these temperature stops is user adjustable in
one-degree increments, and these settings are protected by a selectable 2-
digit code to prevent unauthorized tampering. By default, this 2-digit code is
“00”, and the temperature stops can be used as-is with this code.
27
