For detailed instructions on programming your Master
Control, refer to the RadioRA
®
Setup Guide that is included
with an RF Signal Repeater.
NOTE:
Master Controls will not operate until they have been
programmed.
ON
OFF
ON
OFF
ON
OFF
Installation
Installing a Wall-Mounted Master Control in a newly installed wallbox.
Check off Steps as completed.
Step 1
Turn power off at circuit breaker panel or remove
fuse from fusebox.
Black
White
Bare copper
or green
ground wire.
Green
ground wire.
Wiring Diagram
Neutral
120/127V
50/60Hz
Black
Ground
Green
Master Control
Hot
White
Hot
Neutral
Step 3
Attach wallplate adapter. Mount and align control.
Snap on Claro
®
wallplate (purchased separately).
Step 4
Turn power ON.
ON
OFF
ON
OFF
ON
OFF
Tighten screws
until snug.
Align Control.
Snap on wallplate.
Operation of the Master Control
Button
Turns lights on/off.
LEDs
Glow when associated
Room or Scene lights
are on.
Labels
Printed and blank
labels provided.
All On
All lights on.
All Off
All lights off.
ALL ON
ALL OFF
Dining
Den
Rec Rm
Family
M Bedrm
Brkfast
Morning
Dinner
Relax
Goodnite
Raise
Brighten ROOM or SCENE lights*.
Lower
Dim ROOM or SCENE lights*.
* To select the ROOM or SCENE button you
wish to Raise or Lower, quickly tap that button
twice.
Important Wiring Information
Twist wire
connector tight.
Be sure no bare
wire is exposed.
When making wire connections, follow the recommended strip lengths and combinations for the
supplied wire connectors.
Note:
Wire connectors provided are suitable
for
copper wire only.
For aluminum wire, consult an electrician.
Small
Large
Small:
Strip insulation 3/8" for 14 AWG wire
Strip insulation 1/2” for 16 or 18 AWG wire
Use to join one 14 AWG supply wire with one 16 or
18 AWG control wire.
Large:
Strip insulation 1/2" for 10, 12 or 14 AWG wire
Strip insulation 5/8" for 16 or 18 AWG wire
Use to join one or two 12 or 14 AWG supply wires
with one 10, 12, 14, 16, or 18 AWG control wire.
Step 2
Wire the Control.
Using the wire connectors provided:
• Connect the master control
green
ground wire to the
green
or
bare
copper
ground wire in the wallbox.
If there is no ground wire in your
wallbox, consult an electrician.
• Connect the
black
control wire to
the HOT wire coming from the
breaker panel.
• Connect the
white
control wire to
the NEUTRAL wire coming from the
breaker panel.
