After the function is determined, press the " Enter Button
" ( 3-4, Fig. 1 ) to save the selection function into
memory IC permanently. Press the " Esc Button " ( 3-3.
Fig. 1 ) will revert to normal display screen.
6. HOW TO SEND THE DATA OUT
FROM THE METER
1)If intend to send the data out from the meter, it
should cancel the " Hold function " and the " Record
function " first. The display will not show the " HOLD "
and the " REC " marker.
2)Press the " Send Button " ( 3-5, Fig. 1 ) at least 2
seconds until the lower display show " 232 ", then
release the button.
3)Push the " Send Button " ( 3-5, Fig. 1 ) once, then
both the upper and the lower display will flash slowly,
at the same the storage data logger data will be send
out the meter from the " RS-232 Output Terminal " (
3-8, Fig. 1 ).
4)If intend up load the data to the computer, then
should connect the RS232 cable ( optional, model :
UPCB-01) and apply the Data Logger software (
optional, Model : SW-DL2005 ).
14
