Lutool LT3IN1, Instruction Manual

Page: 21 / 31

NOTE : Remove the saw blade in the opposite way.
Warning: Before installing the battery pack with this tool, always carefully pull on the
blade to make sure it is securely locked in the saw clamping holder. Failure to do so may
result in serious injury.
12.2 To install or remove the battery pack.
Fig. 13
1.
To install : Slide the battery pack (3) into
the battery port, make sure the latches on
each side of the battery pack snap into
place and battery pack is secured in the
tool before beginning operation
2. To remove : Locate latches on both sides of
the battery pack and depress them to slide
the battery out from the tool.
12.3 Switching on and off
Fig. 14

Make sure the battery pack is installed.

Push the lock-off button (5) and
squeeze the ON/OFF switch
trigger (6) as the arrows show on Fig.
13.

When you release the switch trigger,
the saw turns off.
12.4 Speed adjustment (Refer to Fig. B)
By turning the speed control dial (1) upward or downward, you can vary the speed.
The speed should be adapted to the material being cut. In general, higher speeds will allow you to cut
work-pieces faster but the service life of the blade will be reduced.
Position “1” denotes the lowest speed. Position “6” denotes the highest speed.