Lupus LE 180, Manual, Page: 85 / 114

35
5 Use daily schedule:
Un-check : Schedule record not applied – When motion detection function is
enabled, motion alarm is triggered by any motion-event without setting up the
schedule.
Check : Schedule record applied – motion alarm is triggered only by the
motion-event within the scheduled timeline.
Schedule
：
-
Select time grid ON from time 0:00 to 24:00. Alarm will be triggered by
motion-event within the selected timeline (each grid represents half an
hour).
-
Move the cursor to any white grid area, hold the left button and move
the cursor to draw the grid from white to blue. Alarm will be triggered
by motion-event within the selected timeline.
-
Move the cursor to any blue grid area, hold the left button and move the
cursor to draw the grid from blue to white. Alarm will not be triggered by
motion-event within the selected timeline.
-
Select start and end time, from the starting tome hold the left button
and drag along to the selected ending time. This enables multiple grids
to be selected at once.
6 Click [Apply] button to complete the setup.
Click [Apply] button to complete the setup.
NOTE: Select either one of the function [Save the motion snapshot to a JPG file] or
[Save motions to an AVI file on the SD Card], but not both.
NOTE: When the condition of the bandwidth is inadequate, unstable, or SMTP setup is
incorrect. The system may not be able to send the motion event notification by e-mail and
a message appears: “Some Motion Detection JPG files are failed to be sent via email
or upload to FTP due to unstable bandwidth or wrong SMTP/FTP settings. To
ensure you can receive the email or upload to FTP accurately, please make sure the
quality of network or check the SMTP/FTP settings”. To ensure that user can
successfully receive e-mail or upload, it is suggested that the user should determine the
quality of the bandwidth and check whether SMTP/ FTP has been correctly setup.