DMX OPERATION
- Advanced Settings
1.
Press the
5
push button to enter the main MENU.
2.
Navigate through the main MENU with the
5
knob and press the
5
push button to
confirm selection.
3. Rotate the
5
knob to select
DMX ADVANCED,
press the
5
push button to confirm
selection.
4.
Select one of the options among the
DMX BIT
,
DMX SIGNAL LOSS
and
RDM ENABLE,
press
5
push button to confirm the selection.
DMX BIT:
Resolution of the DMX control. 8bit 1 channel per function and 16 bit 2 channels per
function.
1.
Select the
DMX BIT
item by pressing the
5
push button.
2.
Rotate the
5
knob to choose between
8bit / 16bit
, press the
5
push button to confirm
the selected setting.
See
DMX PROTOCOL MANUAL
.
DMX SIGNAL LOSS:
T
his feature allows to choose the device’s behaviour in case of a DMX signal loss.
1.
Select the
LOSS DMX SIGNAL
item with the
5
push button
2.
Rotate the
5
knob to select the device’s behaviour between
BLACK OUT /SETTINGS
LAST / SETTINGS 1min
, press the
5
push button to confirm the setting.
Black out:
The device switches off.
Settings Last:
The values of the last selected setting are maintained over time until the
device is switched off.
Settings 1min:
The values of the last selected settings will be maintained for one minute
and then the device will switch off.
RDM Enable:
ON/OFF, enable/disable RDM Protocol
MODE
CCT
RGBW
HSI
PRESET
EFFECT
CCT/HUE
5
CT 2800K to 10000K
-
HUE 0º to 100º
-
"See EFFECT table"
GN/SAT/COLOR
6
« »
1
« »
3
GN -1.00 to +1.00
-
Select function R/G/B/W/CT/GN
Change values of the function
SAT 0 to 100%
-
-
"See EFFECT table"
Change Preset
Change Effect
INTENSITY
4
Light Intensity
from 0 to 100%
In
CCT
,
HSI
,
RGBW
and
PRESET
Mode, the
« »
key selects the
STROBE
page and the
« »
key exits the
STROBE PAGE
.
In the
STROBE PAGE
it is possible to set
DIMMER
value and the
STROBE
frequency by rotating
the
5
button.
ATTENTION
:
STROBE
frequency = 0 means
STROBE
effect
OFF
.
A. CCT MODE:
Warm and cold white control mode. It allows you to adjust colour temperature
(CCT), green/magenta compensation (GN) and light intensity.
This is the default setting.
*
*
*
*
*
LIGHT MODES
