Lupine Wilma R, Manual

Page: 18 / 23

34 35
Deut
sc
h
Engli
sh
1.
Recover factory settings:
Press and hold the button for about 8 seconds, until 5 red LEDs turn on.

release the button
2.
Disconnect the battery, and all factory settings will be restored.
This mode offers a slow flash mode.
RVLR:
This mode is extremely irritating and may by no means be misused.
Flash 15hz: (Disorientation)
SOS will continue until the battery is empty. Improper use of the SOS signal is punishable by law.
SOS:
Alpine SOS will continue until the battery is empty. Improper use of the SOS signal is punishable by law.
Alpine SOS:
Customizing the brightness levels
Press and hold the button until one green LED lights up.

release the button
The range of brightness levels you can select will begin
automatically to cycle, as shown below.
Press the button at the brightness level you want.

the first power-on click is presented
You have the option to setup to 4 brightness levels, in any sequence
0.3 W
brightness level
3 W
brightness level
7 W
brightness level
28 W
brightness level
14 W
brightness level
RVLR*
1.5 W
brightness level
5 W
brightness level
23 W
brightness level
10 W
brightness level
SOS*
19 W
brightness level
Alpine SOS*
4.
3.
2.
1.
Upon releasing the button, the sequence
of brightness levels automatically
restarts, allowing you to set a second
level in the same manner as the first click
set-up. This process can be repeated up
to four times, but will stop when you quit
making further selections, thus allowing
your light to operate in 1-step, 2-step,
3-step,-or 4-step modes.
Default setting
Flash*
* Will not be signalised by status LED
Note: All changes to the light can also be made
by the free Light Control App for IOS and And-
roid. With the App it is also possible to remote
control the light and the status monitor offers
additional informations.