Pull the pins of the bulb-reflector out of the terminal block. Slide the pins of the new bulb
carefully into place. Adjust the bulb-reflector as before and replace the glass and ring.
Insert the holder and tighten the screw with moderate force. Your Lupine is now finished and
ready to blaze the trails again.
Connectors:
In normal conditions, the connectors do not need special attention. However if you use the
light in very humid and/or corrosive conditions they should be greased with the included
dutch grease. Do not use contact-sprays or contact-greases! They contain corrosive
ingredients that will damage the connectors.
Transport:
If you are transporting your light inside a bag or box, or in a situation where the button may
accidentally be pressed: Always unplug the battery from the lamp unit.
Storage:
Store the battery for short periods of time in a fully charged state. Disconnect it from the
lamp unit. Charge the battery fully before using the system again. If you intend not to use it
for a long time (over 3 months), we strongly recommend to store the battery on a cold
place!. This will prevent against over discharge. It will need just 1 charge cycle to reach full
power again!
6.)
T
ROUBLESHOOTING
Failure Caused
by
Solution
Over discharged battery. Charge!
Lamp does not light and the LEDs
on the PCS do not flash during
initialisation.
Battery is not or not
correctly plugged into
the light.
Check all connections
.
Lamp does not light, LEDs of the
PCS do flash during initialisation. Bulb has blown
Replace bulb
Battery was not in use
for a long time and has
become "lazy"
Battery is new.
After 2-3 cycles the battery
will operate correctly
Battery is very old
Replace with new battery
Cold temperatures
Keep the battery warm
Burn times are too short.
Charger is defective
Replace charger
N
I G H T
M
A R E
P
R O
6