N
I G H T
M
A R E
P
R O
3
PCS v3.3 switch :
The PCS v3.3 is designed for use on the right hand side of the lamp (see fig.3). Before
attaching the velcro strip to the handle bar, ensure that the surface is free of dirt and oil. The
velcro strip should be applied at room temperature, colder temperatures will cause the
adhesive not to work.
For applying the O-Ring to fix the switch to the handlebar see the separate information sheet
"Technical Information PCS v3.3".
An optional upgrade mounting bracket is also available for the switch (Peppi V3).
Battery:
Slide the battery bottle into the cage and loop the Velcro strap around the cage and bottle.
Make sure that the battery cables are routed in such a way that they will not become tangled
in any moving parts.
Now plug the rechargeable battery to the lamp and your NightMare Pro is ready to go.
Adjusting the cable length:
Some spare length of cable is retained into the top of the battery bottle. Open the bottle (see
"Opening the bottle" in chapter "Care and storage"), unscrew the cable inlet and adjust the
cable length. Close the bottle and tighten the cable screw again.
Caution! Adjusting the length of the cable with the bottle closed might damage the cable
connections at the battery!
3.)
U
SING THE LIGHT
Initialising:
Plug the lamp to the fully charged battery. The software of the PCS remote controller will do a
self test (signalled by 2 x short flashes of three of its LEDs ).
The Nightmare Pro is ready to work now. (for more details see: "Technical Information PCS
v3.3")
Switching on:
Pressing the switch turns the lamp on. It will operate on high beam. (signalled by the blue LED
on the switch).
Dimming:
Pressing the button once, after the light has stablised, will switch the light to econo mode
(the blue LED is off). By pressing the button again the light will return to high beam mode.
Switching off:
Press and hold the button for 2 seconds until the light switches off.
Controlling the remaining light time:
The electronics of the PCS v3.3 not only control the high and low beam but also protect the
rechargeable battery against over-discharge and includes a low battery indicator.
Low battery is signalled by the yellow and the red LEDs.
When the yellow LED lights:
Significant amount of the capacity is gone!
Red and yellow LEDs lights:
Light will automatically switch off
in
a
few
minutes!