Lupine BLIKA R, Owner'S Manual

Page: 19 / 21

Accessories
36 Blika R
1. Plug the included Wiesel charger into an outlet
2. Connect the charger to the battery, charging starts automatically the LED turns red
3. The battery can be left plugged into the charger for an indefinite period. Although this will not damage
the battery, it is not advisable for Li-Ion batteries since they do not require conservation charging.
4. When the battery is fully charged the LED on Charger turns green
Charging Batteries

Warning! This charger is to be used to charge rechargeable Li-Ion batteries only.
It is NOT suitable for charging NiMH batteries!

Do NOT use non-rechargeable batteries. – Risk of explosion!

This charger may be opened ONLY by the manufacturer!
Battery:
If you intend not to use the lamp for a longer period of time, fully charge and store it at
a cold and dry place. When kept in a cool place, the annual self-discharging rate for such
batteries is 15 %.
Product Care and Storage
Light:
After use in dirty areas, clean the lamp and the cables externally with warm water and some mild
detergent.
Important!
Because of the delicate sealings, we do not recommend to open the lamp.
A leakage in consequence of opening the light is excluded from warranty! Before you try to repair
something on your own get in touch with our helpful Service Team.
Productcare, Storage and Charging
English
37 Blika R
Problem
The light does not come on
and the power LEDs do not
flash when the battery is
plugged into the lamp.
With the battery plugged in,
the power LEDs do not come
on, but the PCS LEDs flash.
The runtime is too short.
Even after charging only
the 20% LED will light up
at the Smartcore battery.
Cause

Extremely discharged battery

Battery not plugged into the
light or not plugged in
properly

Faulty LED unit

Discharged battery

Old battery

Very low ambient
temperature

Faulty charger

Unsuitable battery

The indicator was reseted
Solution

Charge the battery

Check all plug contacts

LED unit needs replacement.

Get in touch with Lupine

Charge battery

Replace battery

Keep battery warm

Replace charger

Use original Lupine battery

Discharge the battery with
your light and fully charge it
afterwards
The lamp does not recogni-
ze the transmitter.

Lamphead and transmitter
are not linked

See chapter operation
remote control
The transmitter does not light
up while pressing the button
and the lamp does not react.

Button cell empty or wrong
side up

See chapter operation
remote control
Troubleshooting