Luna 20645-0108, Original Instructions Manual

Page: 44 / 112

42
NO-VOLT SWITCH
NOTE:
The no-volt switch has no-volt release and emergency stop featu-
re. This feature is intended to prevent the unauthorized starting.
1. To turn machine “on”, raise the “emergency stop cover” up, and
push the green button (with “I” symbol) about 1 second.
GETTING TO KNOW YOUR BELT & DISC
SANDER
WARNING! To avoid injury from accidental start, remove
the plug from power source outlet before making any
adjustments..
1. Hex socket head screw. Loosening screw allows belt bed to
raise to the vertical position.
2. Tracking knob. Turning knob counterclockwise causes sanding
belt to move towards the disc; otherwise to move away from
the disc.
3. Sanding belt.
4.Tension lever. Sliding lever to the right releases the sanding
belt tension; sliding lever to the left applies belt tension.
5. Work support hex screw.
6. Work support. Supports the workpiece on the sanding belt.
7. Base
8. Belt bed
9. Mounting holes
10. No-volt switch
11. Sanding disc
12. Sanding paper
13. Work table assembly