Luna 20556-0105, Manual, Page: 37 / 88

34
10.1 Regularly clean the thicknessing bed spindles from chips and
dust and lubricate with spray oil. (Lunas best. nr: 592614614).
10.2 Keep infeed/outfeed tables and thicknessing bed free of resin.
Clean regularly with kerosene or petrol, then coat with a light film
of waz antisezing paste to enhance gliding of stock on table.
11.0 Safety Instructions
• Regularly check that blades and lock bars are locked tight in cut-
terblock.
• Max. allowable blade projection over cutterblock 1.0 mm/0.04
inch + 10%.
• Never remove any of the machine’s safety guards other than for
servicing and repair work. Keep guards operational at all times.
• Set and secure safety guards in position before operating machi-
ne.
• When operating machine in enclosed spaces connect to a dust
collector.
• This machine must be safety earthed. The yellow/green (green)
lead is the earth conductor.
• Regularly check anti-kickback fingers for proper operation.
• Always wear eye protection.
• Rebating, tenoning, moulding and recessing may not be underta-
ken without the use of special guards.
• Never make jointing or planing cut deeper tan 3 mm or 1/2”.
12.0 Use Responsibility
This machine will perform in conformity with the description con-
tained in this manual when installed, operated, maintained and
repaire in accordance with the instructions provided.
This machine must be checked periodically. Defective equipment
(including power cable) should not be used. Parts that are broken,
missing, plainly worn, distorted or contaminated, should be repla-
ced immediately. Should such repair or replacement become
necessary, it is recommended that such repairs be carried out by
qualified persons.
This machine or any of its parts should not be altered or changed
or changed from standard specifications. The user of this machine
shall have the sole responsibility for any malfunction which results
from improper use or unauthorized modification from standard
specification, faulty maintenance, damae or improper repair.