| + 44(0)208 144 1694 | [email protected]
Lumishore USA 7137 24TH Court East Sarasota, Florida 34234 | (941) 405-3302 | [email protected]
Lumishore UK, Unit D12, Upper Fforest Way, Swansea Enterprise Park, Swansea, SA6 8QR
3
4. Apply a continuous thick bead of sealant to the back of the light, making sure the recess on the outer
edge is slightly overfilled. Also apply a bead of sealant around the cable gland. Refer to image above.
5. Push the power cable through the hole and align the light with the pilot hole screws.
6. Attach the light using the 3 supplied screws by hand tightening with a screwdriver.
IMPORTANT: Do not over tighten. Do not use power tools to tighten screws.
7. Use a damp cloth to wipe off excess sealant that has squeezed out around the light. DO NOT use
chemical cleaners or solvents.
IMPORTANT: Refer to the directions on the sealant to make sure it has fully cured before
launching the boat into the water.
Electrical installation
There are three control options for the SMX53 lights, please skip forward to the section that applies to your
type of installation.
1.
Simple ON/OFF switch - See pages 4 and 5.
2.
Eclipse Command Center - See pages 5 and 6.
3.
SUPRA Lumi-Hub & Switch (with optional Supra Bridge for MFD control) – See pages 7, 8, 9, 10 & 11.
