www.Lumishore.com
Lumishore UK Unit 3, Technium 1, Kings Road, Swansea, SA1 8PH, UK | +44(0)208 144 1694 | [email protected]
Lumishore USA 7137 24TH Court East Sarasota, Florida 34234 | (941) 405-3302 | [email protected]
3
4. Now secure the tabs of the bracket drill jig using a suitable tape (fig 8), lift the light and brackets away leaving the drill
jigs in their correct place (fig 9).
5. Use the bracket drill jig to drill a 4mm pilot hole followed by a final drill diameter of 6.5mm for the M6 mounting bolts.
6. Remove brackets from light. Using the supplied fixing hardware fix the brackets to the boat. It is recommended that
marine sealant (3M 4200) is used in and around the mounting holes. The spreader plate is required to go underneath the
mounting surface and provides an even distribution of force when tightening. It is important to note that at this stage
these mounting bolts are to be left loose as this is a crucial step in adjusting the angle of the light in the coming steps.
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Ø4.0mm
Ø6.5mm
Fig. 13
Fig. 14
Fig. 15
DO NOT FULLY TIGHTEN
AT THIS STAGE
