mCove
-
Installation Instructions
Please read all instructions prior to installation and keep for future reference!
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
Models: M-
1. PRODUCT TO BE INSTALLED BY A QUALIFIED
ELECTRICIAN.
2. USE ONLY WITH CLASS 2 POWER UNIT
3. 24 VOLTS DC
4. SUITABLE FOR DAMP LOCATIONS
5. SURFACE MOUNT ONLY
6. SUITABLE FOR INSTALLATION WITHIN THE CLOSET STORAGE SPACE
7. INHERENTLY PROTECTED
wall
anchor
3.1
IF CONNECTING MULTIPLE FIXTURES TOGETHER: Insert the joining
brackets into one of the fixture end(s) & tighten the screws on the bracket.
Then slide the connecting fixture into the brackets and secure by tightening
the screws on bracket.
anchor
mark
anchor
Phillips
screwdriver
4.1
corner
fixture
joining
bracket
4.1
Align the anchors onto the marks and tap until the threaded section.
Then screw in the threaded portion of the anchors with a Phillips
screw driver.
4
4.1
3
3.1
3.1
REV0.7
1.1
From the inside of the fixture, remove screws from the center.
1.2
Carefully, rotate and pull the reflector completely out.
1
fixture
reflector
wall
fixture
mark
conduit
2.1
2
2.1
Prior to installing the fixture, power wires must be present near fixture.
Lay the fixture on the desired location, & mark the mounting holes to
the wall. If fixture center hole doesn't match up with the conduit. Make an
additional 1/2" hole to the back of extrusion. Use diagram above to
make hole in the correct location.
DRILL HOLE LOCATION
1.1
1.2
straight fixture
3.1
5
5.1
Bring in the power wires into the fixture . Align the fixture to the anchors
and secure in place using the provided screws. Use the provided conduit
connector if necessary, in accordance with local electrical codes.
wall
Phillips
Screw
power
wires
anchor
5.1
6.1
While holding the LED reflector connect the red & black wires to the power
supply red (24VDC+) & black (24VDC-) wires. For additional wiring
information refer to the power supply instruction.
6.2
Insert the LED panel into the fixture and secure using the provided
screws. Snap-in the cover into the fixture.
6
fixture
reflector
1.2
6.1
screw
center of
fixture
conduit
Page 1 of 3
7777 N. Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
E472444
6.2
reflector
cover
