A.1
Line up the spring clips to the mounting holes. Followed by placing the mounting channel to the surface. Make sure its straight by using a level.
Mounting channel will only house the Kurba body (not the endcaps), refer to illustration above.
A.2
Secure channel to the surface by tightening all the provided screws. If mounting to something other than wood, we recommend using the proper
hardware.
Note:
Prior to installation all 24VDC wires must be present within 72” of the installation. Refer to the power supply
installation instruction for additional information.
Note:
More than one person is recommended for this installation.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
7777 N. Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
Page 3 of 4
E472444
Installation Instructions for
Kurba Vertical & Kurba Horizontal
Models KBL-XX & KBM-XX
1
B .1
Determine the shape of the Kurba layout, then mark the pattern onto the surface. Then place a mounting brackets every 8” (minimum), on the
pattern may vary depending on the amount of curves.
B .2
Secure the mounting brackets to the surface by tightening the screw. If mounting to something other than wood, we recommend using the
proper hardware.
1.1
Once the location or pattern is determined for Kurba to be installed too. Start off by marking the area, depending on the pattern of installation
the amount of bracket may vary. Reference one of the options below to continue.
mounting
bracket
screw
KURBA
Body
A.1
B .1
screw
mounting
channel
endcap
A.2
8”away
(maximum)
B .2
1. PRODUCT TO BE INSTALLED BY A QUALIFIED
ELECTRICIAN.
2. USE ONLY WITH CLASS 2 POWER UNIT
3. 24 VOLTS DC
4. SUITABLE FOR WET LOCATIONS
5. SURFACE MOUNT ONLY
straight run with mounting channel
curved run with mounting brackets
Please read complete instruction prior to installation and keep for future reference!
spring clip
mounting
channel
REV0.3 06262018
