5. RESET
In the case you need to reset the unit without the web interface, the
GigaCore 10 and GigaCore 10 with PoE off ers diff erent levels of reset,
based on the ones you can fi nd in the web interface.
Reset:
The unit is brought back to its default confi guration,
with the default IP address printed at the back of the unit.
Profi les stored in the device are preserved
Default login: admin
Default password: No password
Reload Default:
The profi le stored in slot one is reloaded. The
“Reload Default” is available only if the profi le stored in slot
one has been locked through the utility menu. If this profi le
is set with a password, then the user will need to enter it
through the web interface to access the switch’s menu.
Default login: admin
Default password: No password
Factory Reset:
With a factory reset the device is fully reset to
the state it left Luminex and ALL data will be erased.
Default login: admin
Default password: No password
THE FOLLOWING RESET PROCEDURES CAN ALSO BE ACHIEVED
WITH THE FRONT-END PANEL’S JOG!
5.1 Reset
Condition 1: The device is currently running
Condition 2: There is no profi le set as default profi le
Hold the mode button for at least fi ve seconds to see the four status
LEDs blink red. Releasing the mode button while the LEDs are blinking
red will reset the unit.
Be aware that releasing the mode button during the fi rst fi ve seconds
before the LEDs start blinking red will cancel the operation.
Be aware that releasing the mode button during the fi ve seconds after
the LEDs are blinking red will cancel the operation.
5.2 Reload Default
Condition 1: The device is currently running
Condition 2: The profi le stored in slot one needs to be locked through
the utility menu
Hold the mode button for at least fi ve seconds to see the four status
LEDs start blinking green. If you release the button whilst the LEDs are
blinking green, the unit will reload the profi le stored in slot one.
If you wait an additional fi ve seconds, the status LEDs will start blinking
red to provide you with a reset.
Releasing the mode button while the LEDs are blinking red will reset
the unit.
Be aware that releasing the mode button during the fi rst fi ve seconds
before the status LEDs are blinking green will cancel the operation.
Be aware that releasing the mode button during the fi ve seconds after
the status LEDs were blinking red will cancel the operation.
5s
Hold the reset button
Release the button =
Reload default
Release the button = Reset
Function
5s
5s
GREEN BLINK
RED BLINK
Timing
5s
Hold the reset button
Release the button = Reset
Release the button = Cancel
Function
5s
5s
RED BLINK
Timing
24
