Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is
fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the water
run to make sure that the water is clear and free of impurities. If this precaution is not taken,
there is a risk that the water inlet can get blocked and damage the appliance.
The water supply to the appliance can also be connected to the house
it
does not exceed a temperature of 60 C.
In this case, the wash cycle time will be shortened by about 15 minutes and the wash
efficiency slightly reduced.
The connection must be made to the hot water line following the same procedures as those
for the connection to the cold water line.
hot water pipe, as long
Once the appliance is positioned, adjust the feet (screwing them
In any case, the appliance should not be inclined more than 2 .
in or out) to level the height of
the dishwasher.
Insert the drain hose into a drain pipe with a minimum diameter of 40 mm, or let it run
Use the special
with the appliance. The free end of the hose must be at a height
between 400mm and 1000mm and must not be immersed in water.
into a sink. Make sure to avoid bending or
crimping the hose.
plastic hose clip that comes
FRONT VIEW
Inlet pipe connector
Drain pipe connector
POWER
OUTLET
SINK
DISHWASHER
Min 100mm
If the sink is higher than 1 metr from the floor, the excess water in hoses cannot
be drained directly into the sink. It will be necessary to drain excess
water from hoses into a bowl or suitable container that is held outside and lower
than the sink.
e
Page 12
Dishwasher
After Sales
1300 726 642
Support
Cold Water Connection
Hot Water Connection
Levelling the Appliance
Drain Hose Connection
WARNING!
DO NOT BEND IN ANY WAY !
How to Drain Excess Water
From Hoses
