Lumex FR566DG, Assembly And Operating Instructions Manual

Page: 7 / 24

FR566DG-INS-LAB-RevF16 7
Upholstered Back Assembly, All Models
bracket and link to be even
threaded knob through
large hole in bayonet link
kd bracket
bayonet link
threaded knobs
upholstered back
upholstered back’s kd brackets
upholstered skirt
steel tube
mechanism’s bayonet links
1. Lift the skirt on the rear of the upholstered back. To make assembly easier, hold skirt up
with a small piece of tape to fully expose the kd (knock-down) brackets that are to be
mated to the two bayonet lugs on the recliner mechanism.
2. Remove two pre-installed threaded knobs from back (one on each side).
3. Carefully guide the upholstered back onto the mechanism, inserting both bayonet links
at the same time through the two cutouts located in the bottom of the back.
4. Push down firmly on the back until the recliner mechanism bayonet links are fully
engaged into the upholstered back kd brackets. The top of bayonet link should be even
with top of kd bracket, as shown above.
5. Once the back is properly seated onto mechanism, insert the threaded knob through
bayonet link, kd bracket and steel tube (one on each side). Secure hand tight.
6. Remove tape and lower upholstery skirt. Secure back skirt with the hook and loop strips
on the skirt.