Fix canopy plate (C) with four screws (J).
Notes:
Make sure to have a steady hold of the fixture. So,
it is never hanging loosely from POC if installation
is not complete.
J
POWER SIDE
NON POWER SIDE
Make electrical connections between POC (Power
Over Cable) (K) and the remote driver feed (L). Then,
make connections between the driver and the main
power (M) with marettes (N).
Notes: Connect the
negative (-) POC (black mark on the fixture) to the
black wire and the positive (+) POC (red mark on
the fixture) to the red wire.
C
Secure the canopy driver (D) with screw (O).
O
D
Put the canopy plate (B) and canopy (C) back in place
using the decorative nut (A).
POWER SIDE
NON POWER SIDE
CONTINUOUS SYSTEM
For a continuous system, repeat steps 1 to 11 for all
mountings.
A
B
C
I
K
L
M
N
Pull all wires (H) out through canopy plate (C)
and
cut the excess cable
with an aircraft cable
cutter(I).
Notes:
POC (Power Over Cable) should
have just enough length to make the connection
inside of J-box
.
Height adjustment of the fixture
must be done at this step.
DRIVER
H
C
www.lumenwerx.com (T) 514-225-4304 (F) 514-931-4862 © All rights are reserved to LumenWerx ULC.
RIM-PENDANT-REMOTE-DRIVER-POWER OVER-CABLES-INST.
October 7, 2019
Page: 2 / 3
LumenWerx ULC. reserves the right to change or modify product specifications without notification
7
8
9
10
11
12
PENDANT - CANOPY DRIVER BOX - POC
RIM LINEAR
W W W . L U M E N W E R X . C O M
