Use the canopy plate (C) as a model to mark 4 holes.
C
Loosen the decorative nut (A) on the canopy (B).
Separate the canopy (B) from the canopy plate (C).
B
C
A
NOTE
: Wire dimming conductors as Class 1
Unscrew to remove the canopy driver (D) from the
canopy plate (C) in the order of the numbers.
Mount and turn the canopy plate (C) to place on the
junction box (E).
POWER SIDE
NON POWER SIDE
Remove the canopy plate. Drill holes (Ø 1/4”)
following the marks. Install #8 screw anchors (F) .
POWER SIDE
NON POWER SIDE
Pass all cables (H) through the canopy (B). Insert
them into the griplock (G). Adjust the cables (H) by
pushing the feeder tube.
B
H
G
D
C
C
E
F
www.lumenwerx.com (T) 514-225-4304 (F) 514-931-4862 © All rights are reserved to LumenWerx ULC.
RIM-PENDANT-REMOTE-DRIVER-POWER-OVER-CABLES-INST.
October 7, 2019
Page: 1 / 3
LumenWerx ULC. reserves the right to change or modify product specifications without notification
4
2
1
5
3
6
PENDANT - CANOPY DRIVER BOX - POC
RIM LINEAR
IMPORTANT
: Installation instructions are shown with RIM 4 and applies to all RIM LINEAR fixtures
W W W . L U M E N W E R X . C O M
