3) Installation and operation:
Before using the lamp, remove any packaging material from it. Dispose the packaging material immediately because
it can be dangerous for children! Fix the supplied table clamp safely on a table. Check the load-bearing capacity of the
tabletop. Damages can occur in case of soft tabletops for which we can not assume any liability! Set the lamp in the
desired position. Put the power plug into the socket and switch on the lamp on the power switch. Now the lamp is ready
to use. Thanks to the light switch which is accessible when the lid is closed, the lamps of the series 721X and 821X are
also perfect desk lamps. The lamps of the series 821X do have an additional set control option for the luminosity. The
luminosity can be adjusted in five steps of luminous intensity with the touchpad (1 and 2).
4) Cleaning:
Please do not use any chemical cleansing agents. Clean the parts of the lamp with a soft cleaning cloth. Before cleaning,
remove the power plug.
5) Exchange of lenses:
The lenses in the
Lumeno®
lamps can be replaced. Please take into consideration that the arm springs are coordinated
with the weight of the lenses. You can change a lens of 3 dioptres with a lens of 5 and vice versa, a lens of 8 dioptres
with a lens of 5 and vice versa. It is not possible to replace a lens of 8 dioptres with a lens of 3 dioptres or vice versa.
Attention:
Due to the high weight of the large lenses in the 851X series, it is not possible to exchange the lenses for a
different magnification. The arms are optimally adjusted to the weight of the lens.
Exchange of lenses of the series 821X:
Remove the power cable. Move the body of the lamp in a horizontal position. Turn the mounting ring of the lens (4)
counter clockwise and remove it. Lift the lens upward, out of the casing. For the insertion of the exchange lens you have
to proceed in the reverse order.
Exchange of lenses of the series 721X and 851X (by technical staff):
After removing the power cable, remove also the four Phillips screws from the LED cover and pull it out off the lamp
body. Remove the lens and replace it with the desired lens. Now instal the cover.
6) Service and guarantee:
The used high performance SMD LEDs have a burning time of four thousand hours. In the improbable case of defect
LEDs or other parts of the lamp, only authorized specialist companies or Traderia GmbH should exchange or replace
them. Replacement parts should be purchased from Traderia GmbH. The manufacturer offers a warranty of two years for
this product. In a service case please contact your dealer or Traderia GmbH.
7) Available accessories and replacement parts:
• Lenses with 3, 5 or 8 dioptres (corresponding to an
enlargement of 1,75, 2,25 and 2,75). 8dioptre lenses
are not available for 851X series!
• Low distortion crystal clear lens available in three
different dioptre options
• Tripod with wheels (6159) with colour-matched details
• Table clamp (6171)
• Table bracket 6180
• Universal bracket for the assembly on a table or a wall
(6179U/6179W)
Universal bracket 6179U
Table stand 6180
Tripod 6159
