Lumenlab eVo v1.1, User Manual, Page: 14 / 28

14
Basic operation
Turning on the projector
When the projector receives mains power, it will go into standby mode and
the indicator light will be red.
Press the power ( ) button on the projector case or on the remote control.
The fans will start up and the indicator light will be yellow.
When the indicator light turns green, the projector is ready for use.
Note: When using the remote control, make sure it is directly aimed at the IR
on the front of the projector case (see page 7).
Turning off the projector
Press the power ( ) button once. The indicator light will flash in green.
Press the power button again within three seconds to confirm shutdown. The
projector will begin shutting down and the fans in the projector will keep
running for about three minutes.
Finally, turn off the main power switch.
Before moving the projector:
1. Unplug the power cable.
2. Disconnect any other cables.
3. Cover the lens with the lens cap.
Adjusting the focus
Turn the projector lens to the right or left until the image is crisp and in focus.
Basic operation