Dec.2018 Rev 1.0
www.getfpv.com
Vbat: Battery voltage
6~36V DC IN
G: Ground
Curr: current sensor signal IN
R6: UART6_RX
S1/S2/S3/S4: ESC signal
T6: UART6_TX
Rssi: Analog RSSI IN (0~3.3V)
3V3: LDO3.3V Max.200mA
DA: I2C1_SDA
CL: I2C1_SCL
PA4: for analog Airspeed in INAV
No function in BF
C1: Camera-1 video (Default)
C2: Camera-2 video
***
C1/C2 can be switched via PINIO2 (Modes Tab/USER2)
R4: UART4_RX
T4: UART4_TX
*** R4 has 200ohm built-in, can be remapped to PWM camera control
(CLI
resource camera_control 1 A01
)
Vbat: Battery voltage filtered, Max.1A load on this pad.
(Default ON)
*** ON/OFF
can be switched via PINIO1 (Modes Tab/USER1)
VTX: Video OUT to Video Transmitter
R3: UART3_RX
T3: UART3_TX
S5/S6/S7/S8: ESC signal
LED 3.3: Red, 3.3V Status
LED 0: Blue, FC Status
LED 1: Green, FC Status
MPU
6000
BARO
BlackBox
MicroSD Slot
SH1.0-8P
OSD
AT7456E
MCU
STM32F722RET6
DFU
ICM
20602
Size & Weight: 36x36mm /7g
Holes: Φ4mm, 30.5mm mounting
Packing
1x LUX-F7
1x SH1.0_8pin to 8pin cable
1x SH1.0_6pin connector
6x M3 Silicon Grommets
5V: onboard BEC 5V 2A cont. Max.3A
4V5: 4.4~4.8V, Max.500mA, the voltage is also supplied when connecting via USB
G: Ground
R2: UART2_RX for Serial RX by default,
PPM share R2 pad
T2: UART2_TX
*** T2 can be remapped to softserial_tx1 to get one more Uart for Frsky
SmartPort
(CLI
resource SERIAL_TX 11 A02
)
***
F722 MCU has inner inverter, SBUS can be connected to any unused UART_RX.
***
Frsky FPort, SmartPort, Tramp & SmartAudio can be connected to any unused UART_TX
Buz- & 5V: General active 5V buzzer
LED: 2812 LED signal
R1 & T1: UART1
LAYOUT
