Lumel NA5 Series, User Manual, Page: 56 / 64

#$
Example 4 Programming of an alarm operating in a set interval with delay.
If we want that the alarm 1 will be switched on in the interval from 100 V to 300 V
and operate only after 10 seconds, one must:
l
enter into the programming mode, choose the PrL parameter of the alarm 1
and introduce the value 100
l
transit on the PrH parameter of the alarm 1 and introduce the value 300
l
transit on the tYPA parameter of the alarm 1 and select the function On
l
transit on the dLY parameter of the alarm 1 and introduce the value 10.0
in case of the alarm state duration for a time longer than 10 seconds, the meter will
switch the alarm relay on
Example 5 Programming of an analog output
If we want to programme so that to the displayed value 0.00 mA will correspond
the value 4.00 on the analogue output, whereas to the value 20.00 mA , the
value 20.00 mA, one must:
l
enter into the programming mode, choose the IndO parameter and switch the
individual characteristic On
l
choose the d_H1 parameter and introduce the value 0.00
l
transit on the O_Y1 parameter and introduce the value 4.00
l
transit on the d_H2 parameter and introduce the value 20.00
l
transit on the O_Y2 parameter and introduce the value 20.00
Example 6 Bargraph programming
If we want to programme so that the bargraph was of a ,,sector” type - red colour
between PrL and PrH parameters, one must:
l
enter into the programming mode , choose the tYPb parameter of the
bargraph and choose SEct
l
choose the coLr parameter of the bargraph 1 and choose r
Example 7 Programming a bargraph with a ,,magnifier”
If we want to programme so that the bargraph was blank for the value 0 and full
lighted for the value 150, one must:
l
enter into the programming mode , choose the brL parameter of the bargraph
and introduce the value 0
l
choose the brH parameter of the bargraph 1 and introduce the value 150
All manuals and user guides at all-guides.com
all-guides.com