Lumel NA5 Series, User Manual, Page: 30 / 64

!
– The meter currently checks the value of the introduced parameter at the
moment. In case when the introduced value exceeds the upper or the lower
range of changes given in the table 1, the meter will not make the parameter
record.
– In case of the Input type change, a simultaneous change of the decimal point
follows, optimally for the given input.
– After the supply decay, the current time is reset.
– The recording switching off follows in following cases: switching the recording
off from the programming matrix, change of the input type , change of the
recording time start or the recording time interval , setting Cnt =0, filling of
the memory, and at a renewed switching of the meter on to the network.
– In case of a Intr or Sect bargraph type, it is possible to set only one CurL and
Curh markers (from one alarm). The others are automatically erased.
– Max and Min values are erased in case of changes: input type, individual
characteristic (on, off), writing of standard parameters.
Standard parameters of the NA5 meter Table 2
Parameter description Standard value
typ
nnal (± 40 mA)
lo:n
- 20.0
Hi:n
20.00
func
OFF
Con
0 = manually
d_p
00.00
Cnt 1.0
:nd:
OFF
:_H1
d_y1
:_H2
0
d_y2
typb
Sect
colr
G
brl
- 20.0
brH
20.00
Parameter description Standard value
prl
- 20.00
prH
20.00
typa
OFF
dly
0
H0ld
OFF
Curl
r - Alarm 1 and 3
OFF -other alarms
CurH
rG - Alarm 1 and 3
OFF -other alarms
:nd0
OFF
d_H1
0_y1
0
d_H2
0_y2
baud
9600
tryb
RTU 8N2
All manuals and user guides at all-guides.com