TS210SL 15
OPERATION AND MAINTENANCE AND SERVICE
Setting the blade tilt
Note: Check all the angles before starting to saw.
Undo the locking knob (14) and set the desired
angle.
Tighten the locking knob again.
Rip cutting
Note:
Rehearse every step of the cutting task without
turning the saw on if you are unsure how to hold
the work piece and work safely.
Make a test cut and measure before starting to
rip cut on the actual work piece.
Always let the saw come up to full speed before
starting to cut.
Be extra careful at the beginning of every cut.
When rip-cutting thick work pieces where the
saw blade is set to its maximum height: check
that the riving knife is set to its maximum height
setting otherwise there is a risk of the work
piece fastening on the blade guard. Refer to the
Adjusting the riving knife section.
Hold one side of the material against the rip
fence and the flat face against the surface of the
table.
Do not stand directly behind the work piece
when rip cutting. The work piece can be thrown
back towards the operator.
Place your hands on the work piece and press it
against the table and the rip fence. Feed the
work piece into the blade in a controlled and
smooth motion.
.
Warning: Always use a.push-stick if any of your
hands comes closer than 125.mm to the.saw
blade during the.cutting process. Never use
a.damaged push-stick, replace a.damaged stick
Maintenance and Service
Maintenance and Cleaning
Before any work on the machine itself,
pull the mains plug.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair
should be carried out by an approve service
centre.
– Store the tool, instruction manual and
accessories in a secure place. In this way you will
always have all the information and parts on hand.
Cleaning
– For safe and proper working, always keep the
power too land its ventilation slots clean.
– Remove dust and chips after each working
procedure by blowing out with compressed air or
with a brush.
