TS210SL 09
ASSEMBLY INSTRUCTIONS
Assembly
Avoid unintentional starting of the machine.
During assembly and for all work on the
machine, the power plug must not be
connected to the mains supply.
Carefully remove all parts included in the
delivery from their packaging.
Remove all packaging material from the machine
and the accessories provided.
Before starting the operation of the machine for
the first time, check if all parts listed in the box
content section have been supplied
Note: Check the power tool for possible damage.
Before further use of the machine, check that all
protective devices are fully functional. Any
lightly damaged parts must be carefully checked
to ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Dust extraction
Dust from materials such as lead-containing
paint, different kinds of wood, minerals and
metal maybe harmful to health. Touching of
inhaling the dust can cause allergic reactions
and/or ailments of the respiratory tract of the
user or persons in the vicinity. Certain dust such
as oak or beech dust is considered carcinogenic,
particularly in combination with wood treatment
additives (chromate, wood preservatives).
Materials containing asbestos may only be
processed by experts.
– Always use a dust extraction facility.
– Make sure the workplace is well ventilated.
– Always wear a dust protection mask.
– Observe the regulations valid in your country for
the materials to be processed.
Attach the Table Extensions
1. Make sure that the saw blade is at its lowest
setting. Turn the saw upside down and place it on
the floor with the table facing down.
2. Line the table extension (8) up with the edge of
the saw table (1).
3. Loosely fasten the extension to the table using
hexagon head screws (20) and nuts (21). Repeat
the procedure on the opposite side of the table.
4. Screw the support struts (23) to the table
extensions with washers and nuts.
5. Tighten the nuts when both extensions have
been attached.
