DP20-1630F 14
Positioning the table and workpiece
Lock the table to the column in a position so that the
tip of the drill is just a little above the top of the
workpiece. Always place a piece of back-up material
(wood, plywood) on the table underneath the
workpiece. This will prevent splintering or making a
heavy burr on the underside of the workpiece as the
drill breaks through. To keep the back-up material
from spinning out of control, it must come in contact
with the left side of the column, as illustrated in
picture.
WARNING!
To prevent the workpiece or the back-up
material from being tornfrom your hand while
drilling, position them against the left side of the
column. If the workpiece or the back-up material are
not not long enough to reach the column, clamp
them to the table. Failure to do this could result in
personal injury.
ADJUSTMENTS
Summary of Contents for DP20-1630F
Page 24: ...DP20 1630F 22 Parts Diagram...
