Lumberjack DP20-1630F, Safety And Operating Manual

Page: 12 / 24

DP20-1630F 10
Installation the chuck
1. Locate the chuck in the box of parts.
2. Clean out the tapered hole in the chuck, also
clean the spindle nose with a clean cloth. Make
sure there are no foreign particles sticking tothe
surfaces. The slightest piece of dirt on the
spindle nose or thechuck will prevent the chuck
from seating properly. This will cause the drill to
“wobble .
NOTE: If the tapered hole in the chuck is
extremely dirty, use a cleaning solvent on a clean
cloth.
3. Tight philip’s head screws of the chuck guard
to quill shaft.
4.Push the chuck up on the spindle nose as far as
it will go.
5. Turn the chuck sleeve clockwise and open the
chuck jaws completely.
6. Lightly tap the nose of the chuck with a piece
of wood to insure the proper seating of the
chuck on the spindle.
Installation the feed handles
1. Locate the three feed handles among the loose
parts..
2. Screw the feed handle tightly into the threaded
holes in the hub.
Installing the belt guard knob
1.To attach the belt guard knob, use the knob and
a pan head screw from the loose parts bag. Insert
the pan head screw into the belt guard and screw
knob. Tighten.
WARNING!: To avoid possible injury, keep the
guard in place and in proper working order while
operating.
Tensioning the belt
NOTE: The drill press is shipped with the belt
installed, but it should be properly tensioned
before use.
1. Lift the guard (A) from the right side and keep it
opened.
2. Release the belt tension lock knobs (B) located
on the both side of the drill press head. Release
tension to the belt tension handle (C) clockwise.
Tighten the belt tension lock knobs (B).
ASSEMBLY INSTRUCTIONS