Lumberjack AG820, Safety And Operating Manual, Page: 9 / 17

AG820 07
ASSEMBLY INSTRUCTIONS
Assembly
Avoid unintentional starting of the machine.
During assembly and for all work on the
machine, the power plug must not be
connected to the mains supply.
Carefully remove all parts included in the
delivery from their packaging.
Remove all packaging material from the machine
and the accessories provided.
Before starting the operation of the machine for
the first time, check if all parts listed in the box
content section have been supplied
Note: Check the power tool for possible damage.
Before further use of the machine, check that all
protective devices are fully functional. Any
lightly damaged parts must be carefully checked
to ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Fitting the additional handle
-The angle grinder must not be used without the
additional handle (4).
- The additional handle can be secured in any of
three positions (A, B, C).
Setting the guard (Fig.3)
- Switch off the tool. Pull the power plug.
- Adjust the guard (5) to protect your hands so that
the material being ground is directed away from
your body.
- The position of the guard (5) can be adjusted to
any specific working conditions. Undo the clamp
handle (a) and turn the cover (5) into the required
position.
- Ensure that the guard (5) correctly covers the
gear wheel casing.
- Secure the clamp handle (a) again.
- Ensure that the guard (5) is secure. Take care that
the safety device is secure. Never use the angle
grinder without the guard.
Test run for new
G
rinding Wheels
Allow the right-angle grinder to run in idle for at
least 1 minute with the grinding or cutting wheel
fitted in place. Vibrating wheels are to be replaced
immediately.