Chapter 3
_________________________________________________________________________________________
_____________________________________________________________________________
BE6020-14
1316A-1 Multi Gas Monitor
LumaSense Technologies A/S
Instruction Manual
Page 44 of 98
Figure 3.8 The BZ 6012 Graphics1 screen showing Concentration
measurement results on two axis. Primary axis used for gases
reported in % the secondary axis for gases reported in ppm.
Channels Field.
The Channels field in the bottom part of the Graphics1 screen is used
to:
Select the gases for which the measurement data is to be
presented in the graphical screen by setting a tick-mark.
Change the scaling for the two axis. The scale is changed by
keying in appropriate values in the Min, Max boxes for each Channel.
After changing the scale and selection of the gases to be shown on
the graph press the APPLY Soft Key to activate the new settings.
1316A-1 Field.
This field is used to change the screen displayed between the up to
four different 1316A-1 to display the measurement result.
