GUIDE
PINS
GEAR
ASSEMBLY
6
6
7
8
B
Warning: The Luminaire should only be used complete with its protective shield (cover)
IMPORTANT INSTRUCTIONS
t
90 C
t
90 C
1m
A.C.N. 010 572 773
A
C
B
4
5
1
3
2
C1613 - 2007_01_REV-003
Lumascape Lighting Industries 2006
©
LUMASCAPE
HEAD OFFICE
T 07 3286 2299 F 07 3286 6599
LUMASCAPE
SYDNEY - NSW
T 02 9519 6860 F 02 9519 8834
LUMASCAPE
MELBOURNE - VIC
T 03 9686 1900 F 03 9686 1700
ECC LIGHTING
LUMASCAPE AGENT - NZ
T 09 379 9680 F 09 308 9328
H.I. LIGHTING
LUMASCAPE AGENT - WA
T 08 9321 5422 F 08 9321 5881
NQ LIGHTING
LUMASCAPE AGENT - NTH QLD
T 07 4031 4490 F 07 4031 5933
LIGHTING PARTNERS AUSTRALIA
LUMASCAPE AGENT - SA
T 08 8232 0074 F 08 8232 0076
Lumascape Lighting Industries Pty Ltd
38-44 Enterprise Street, Cleveland, QLD 4163, Australia
PO Box 1875, Cleveland D.C., QLD 4163, Australia
T 07 3286 2299
F 07 3286 6599
E [email protected]
W www.lumascape.com.au
90
o
RELAMPING
LAMP SOURCE CONVERSION INSTRUCTION
6
Isolate and Open Fixture
Ensure the fixture is electrically isolated.
Loosen the screws with the Allen Key
provided. If necessary gently lever lid out
with a large screwdriver.
Replace Lamp
Remove old lamp and check condition of
lampholder. Check new lamp WATTAGE,
VOLTAGE and TYPE. Insert new
lamp,(Refer installation instruction 4 over.)
Adjust, Aim, Test and Seal
6
8
If necessary, readjust and re-aim gimbal
position.
Test and seal fixture as per installation
Instructions
through to , over.
GIMBAL
LOCKING
SCREW
6
6
7
8
Isolate and
Open Fixture
Ensure the fixture is electrically isolated.
Loosen the screws with the Allen Key
provided. If necessary gently lever lid out
with a large screwdriver.
Remove Gimbal
Remove gimbal by loosening the locking
screw and pulling vertically.
Remove Gear Assembly
Remove gear assembly by pulling vertically
(Note: Gear assembly may be screwed to
fixture body).
Insert New Gear Assembly
Align holes in gear tray with Threaded
Guide Pins in base of fixture and insert
fully, fit S/S nuts to retain
Replace Lamp
Remove old lamp and check condition of
lampholder. Check new lamp WATTAGE,
VOLTAGE and TYPE. Insert new
lamp,(Refer installation instruction 4 over.)
Adjust, Aim, Test and Seal
6
8
If necessary, readjust and re-aim gimbal
position.
Test and seal fixture as per installation
instructions
through to , over.
IMPORTANT INSTRUCTIONS
FOR UNDERWATER USE
www
.lumascape.com.au
T 1-(650)-595-LUMA(5862) 1-(650)-595-5820
LUMASCAPE USA INC
Free Call 1-866-695-LUMA(5862)
For Installation LS345 UNDERWATER
To avoid potential unsafe lamp failure, the luminaire should be switched off at least once a week
DISCONTINUED PRODUCT
