Warranty void if not installed as per installation instructions
INSTALLATION INSTRUCTIONS
Lumascape Lighting Industries Pty Ltd
38-44 Enterprise Street, Cleveland, QLD 4163, Australia
PO Box 1875, Cleveland D.C., QLD 4163, Australia
T
07 3286 2299
F
07 3286 6599
E
W
www.lumascape.com.au
IN0157 - 18 March 2016
Copyright ©2016 Lumascape Lighting Industries Pty. Ltd. ABN 21 010 572 773
www.lumascape.com.au
LS333ANS-2COB
&
LS333AS-2COB
IP68
A.C.N. 0105 72 773
MODEL:
LS333ANS-2COB & LS333AS-2COB
INSTRUCTIONS COVER:
30 V DC Ripple Free Power Supply
UNDERWATER
NOTE:
These installation instructions are accepted in most areas. Some supply authorities may require alternative installation methods.
Should you experience any difficulty, please contact Lumascape directly: phone 07 3286 2299 or email [email protected]
IF IN DOUBT, PLEASE CALL
DANGER
ISOLATE LUMINAIRE FROM POWER
Failure to isolate power
supply before installation or
maintenance may result in
fire, serious injury, electric
shock, death and may
damage the luminaire.
WARNING
FINISHED
APPEARENCE
It is strongly recommended to use
Lumascape power supply or transformer
Use of electronic transformer will
permanently damage luminaire
All connections must be kept dry; failure to
do so may result in product reliability issues
Installation to be done by a qualified
electrician
1
2
3
4
5
6
7
A
1
Luminaire Cable
Connect to a suitable power supply in accordence
with local wiring rules.
2
Suppluy Conduit
Attach to niche gland and use to run luminaire
cable back to power supply.
3
Niche
Install at the time of construction. Use temporary
fibre board shield supplied to cover niche when
concrete is sprayed. About 1.3 m of cable can be
coiled inside the niche.
4
Mounting Lugs
Use to hold niche in place during construction.
5
Mounting Ring
Used slightly adjust luminaire position and rotation
within niche.
6
Luminaire
If your luminaire was ordered with the factory
pre-set tilted optical system make sure to install it
in the correct orientation.
7
Cover Plate
Place in front of luminaire before using screws to
mount luminaire and cover plate to mounting ring.
A
Diffuser Installation
Open luminaire and insert diffuser between
reflector and accessory holder. Re-seal
luminaire.
Single Colour Dim
Wire Colour Designation
Black
30 V DC -
Red
30 V DC +
Grey
(1)
PWM
(1)
Do not connect if dimming
is not required
NOTE: Make sure to pull luminaire cable
through mounting ring before feeding
through conduit and terminating