4
LumaPro Operating Instructions
45C245
60W LED Ceiling Canopy
Installation & Operation:
Disconnect the power by turning off the circuit breaker or by
removing the appropriate fuse at the fuse box. Turning the power off using the light
switch is not sufficient to prevent electrical shock.
1.
Drill four mounting holes into mounting surface using a 1/4” drill bit. Use template to
locate mounting holes.
2.
Use a Phillips Head screwdriver to loosen (4) screws securing fixture light engine/lens
assembly. Remove fixture base plate from fixture.
3.
Use a flat head screwdriver to remove appropriate wire way covering from housing.
This is to be determined by the installer.
4.
Take care to avoid damaging driver, wires and quick connectors and drill holes through
castings over fixture mounting holes.
5.
Affix fixture to mounting surface by installing anchors (not supplied) through fixture
mounting holes into holes drilled into the mounting surface. Be sure to use an anchor
appropriate for the mounting surface in which the fixture is installed.
6.
Add
¼
” bead of exterior grade silicone sealant
around the outside perimeter in the seam between
the mounting surface and the fixture base to inhibit
any moisture from attachment screws.
7.
Reattach fixture light engine/lens assembly to
fixture base housing.
8.
Connect driver OUTPUT leads to quick connect
originating from LED array. Red output
to quick connect with red wires, black output to
quick connect with black wires.
9.
Reattach fixture using two Phillips Head screws
removed in mounting step 2.
Warranty
LIMITED FIVE-YEAR WARRANTY
Should this product fail to perform satisfactorily due to a defect or poor workmanship within FIVE
YEAR from the date of purchase, return it to the place of purchase and it will be replaced, free of
charge. Incidental or consequential damages are excluded from this warranty.
Manufactured for Grainger International, Inc.
100 Grainger Pkwy., Lake Forest IL 60045 U.S.A.
