User’s Manual
... 11
10
... Lukas Blackbox
4. Installation Guide
※
#
For the safety, be sure to check the following items before installation and then install it in
order.
※
#
the installation.
※
#
Clean up the window glass where to attach the blackbox.
※
#
Check the power terminal and the video-out terminal of blackbox in advance before
installation.
※
#
If the lens of blackbox is set to be upward, the product may not work properly (GPS receiving
and event continuous generation)
※
#
To secure the optimum image quality, keep the front window clean at all times.
※
#
may be degraded. Therefore, keep the lens clean at all times.
1. Apply the double-sided
tape to the holding deck of
blackbox.
3. Connect the jack of power
cable to the main body of
product and squeeze the power
cable along the A pillar(pillar
beside the driver's seat).
2. Select the place on the front
window not to interfere the
driver's view and attach the
blackbox. Insert the SD card
into the product.
4. Connect the power cigar jack and then start the engine to
check if the version is displayed on the segment window of
blackbox. (When adjusting the blackbox angle, it is better to
connect the video-out terminal to the display of navigator and
then adjust the angle while looking at the present image.
5. Recommended Installation Angle of Product
Viewing angle of Lukas blackbox can be adjusted up, down, left and right by user. As the
image quality may depend on the view angle, it is better to adjust the angle properly according to
the following explanation.
※
#
Right images are ones photographed at the same time and same place by just changing the up/down angle. Left
blackbox angles are examples for explanation and they can be changed according to the slope of front car window.
Fixed Image 40%
Moving Image 60%
(G-Sensor Z value:
-0.22)
Fixed Image 50%
Moving Image 50%
(G-Sensor Z value:
-0.27)
Viewing angle is
located at the end of
the hood (G-sensor
Z value: +0.15)
It is the image photographed in the
recommended ratio of 4:6 at installation
of product. It maintains the appropriate
brightness and resolution and, as you can see,
it can photograph even the signal light in front
of it when the car stops exactly at the stop line.
This problem occurs when it is bent
excessively downward. As you see, there
is no problem in brightness, but the correct
information can hardly be obtained because
the signal light is not seen.
If the view angle is installed too upward, the
screen gets generally dark due to the sun light
on the left top. As shown here, the brightness
of image may depend on the angle.
Optical lenses have the characteristics that 20% of
left/right ends can get unclear, distorted and varied.
It generates 10% or lower deviation on left/right sides
(10% or lower in MTF basis).
Wait!
※
#
Installation by Impact Sensor: Z-axis value lies on -0.1~-0.3. In case of general sedan, -0.2 is
recommended.
<Not Recommended>
20% 60% 20%
Moving
Image
60%
Moving
Image
50%
Moving
Image
100%
Fixed
Image
40%
Fixed
Image
50%
