Lukas AMIN 30 BSH, Operation Instructions Manual

Page: 6 / 18

16 - AMIN 30 BSH - Stand: 21.11.2008
Always ensure that the main load is transmitted in a radial direction (i.e. on the tool
circumference) and not in an axial direction to the power tool.
Before changing a tool or undoing the compressed air hose, the power tool must be
disconnected from the compressed air supply.
Changing the grinding belt has to be conducted as follows:
- Loose screw (106)
- Remove cover (103)
- Push tension arm (102) towards the tension body (101)
- Remove the old grinding belt and put on the new one
- Put on the cover (103)
- Tighten the screw (106)
- Adjust grinding belt by using the set screw (13)
The rebuilt of the power tool into an angle die grinder has to be conducted as
follows:
- Loose screw (105)
- Take off tension arm (101) and tension body (102)
- Loose and take off cap (12)
- Insert collet (15)
The rebuilt of the power tool into a belt grinder has to be conducted adversely.
After a tool change, the power tool must be test run in a safe place (e.g., underneath
the work bench) with the tool clamped in position.
5. Safety Instructions
Due to the large number of available shaft diameters, there is a risk of confusion
thereby mismatching tool shaft and collet diameter.
The power tool must not be operated with damaged or incorrectly clamped tools as
this may cause vibration.
When machining certain materials, dust and vapour may occur which result in an