AIMING LOW BEAM HEADLAMPS
Low Beam Headlamps are aimed so that the top edge of the high-intensity zone is at the
, and the left edge of the high-intensity zone is at the
vertical center line of the screen. The beam slope knob should be set based on center
height of headlight (see table 1, page 21).
Nominal Vertical Aim Line
Aiming Procedures - Aiming Low Beams - Page 15
INSPECTION LIMITS FOR LOW BEAM HEADLIGHTS
The inspection limits are a range of 4” at 25’. The illustrations below show the range
allowed for vertical and horizontal inspection.
The left side of the “high intensity zone” must fall
within the shaded area for proper low beam
horizontal adjustment.
The top of the “high intensity zone” must fall within
the shaded area for proper low beam vertical
adjustment.
Inspection
upper limit
Inspection
lower limit
4"
0"
4"
4"
4"
Nominal Vertical Aim Line
100 mm
100 mm
100
mm
100
mm
4"
4"
4"
0"
4"
4"
0"
4"
4"
4"
Summary of Contents for SNIPER 5412a
Page 1: ...Ver 020308 Lujan USA...
Page 2: ......