p.2
p.3
13.8VDC power cord input.
!4
EXT (External Speaker) Jack
This jack is for connecting an external speaker.
!5
PTT (Push-to-talk) key
Push the button to talk then release
to receiving mode.
!6
UP key of the microphone
This switch allows increasing a chan-
nel number.
!7
ASQ on and off
When you press this button, the LED
lights for TX and ASQ will light green, then ASQ pen.
!8
DN key of the microphone
This switch allows decreasing a channel number.
!9
MICROPHONE plug
6-pole microphone plug with locking ring nut, to be connected to
socket (1) located on the front side of the radio.
!5
!6 !7 !8
!9
UP
ASQ
DN
Turn the SQUELCH knob anticlockwise until the background noise
is cut. Rotate the SQUELCH knob clockwise (SQUELCH ON) to listen
to the weakest signals.
t
RF GAIN knob
This transceiver uses a high sensitivity and selectivity receiver circuit.
The receiver gain is adjustable with the RF GAIN knob. By rotating
the knob anticlockwise, the receiver gain is reduced. It is conve-
nient to reduce the receiver gain in case of very strong signals from
local stations. This knob only functions at AM mode.
y
OFF/VOL
This knob controls the radio ON and OFF as well as adjusts the vol-
ume. If no signals are being received on the operating channel,
it is suggested to turn on the SQUELCH and adjust the volume to
the desired level while listening to the background noise. When it is
turned on by operating the Volume knob
，
the radio will remember
the channel, frequency, AM or FM used last time.
u
AM/FM mode selector
This switch allows selecting the modulation mode AM or FM.
i
CH9/CH19
This function can select emergency channel CH19 and CH9
Note: In the off state,turn to CH9 can select the frequency of other
European countries, and turn to CH can confirm. Restart the radio
will prompt the current frequency table.
o
TX and ASQ LED
The indicator light is bi-color,red light and green light, transmitting
shows red light, and open ASQ shows green light.
!0
RX Signal Meter
4-bar RX signal Meter to monitor the strength of the received sig-
nals.
!1
DISPLAY
The digital LED display shows the channel.
!2
ANTENNA CONNECTOR
Refer to the section INTALLTION OF THE ANTENNA.
!3
13.8 VDC POWER CORD
