Luisi Air TRENTO, Installation, Use And Maintenance Instructions, Page: 17 / 64

EN
HOW TO USE THE COOKER HOOD
This appliance is intended to suck cooking fumes,
greases and steam. It has been designed to work
in both suctioning mode, with outside evacuation,
and filtering mode.
Outside - discharge version
The cooker hood can be mounted in the version
with outside discharge of suctioned air: in this case
it is necessary to connect the exhausting channel
to the outside (exhausting pipes are not supplied
with the products.)
Non-return valve blockage
In case of outside air discharge installation, fit a
non-return valve to prevent wind and back air from
entering.
Before connecting the air exhaust hose, make
sure that the non-return valves can rotate fre-
ely.
WARNING
Filtering mode
In case fumes and vapour cannot be evacuated
outside, the appliance can be used in the filtering
mode.
Activated charcoal filters are required for this type
of cooker hood.
Air recycled through the charcoal filters is recircu-
lated into the kitchen, thanks to a duct conveying
the air on one side of the cabinet (Fig. 9) .
CAUTION
Installation must comply with the regulations
in force regarding the ventilation of enclosed
environments. In particular, discharged air
must not be conveyed into a duct used for
fumes discharge or discharge from applian-
ces using gas or other combustible materials.
The use of discontinued ducts is not allowed
without the approval of a qualified technician.
REMOVING THE GREASE FILTER,
MOUNTING THE ACTIVATED CHAR-
COAL FILTER.
The removal and fitting of both the grease filter
and the charcoal filter shall be carried out with the
downdraft open. To open the downdraft, push the
glass downwards so as to make the opening of
the appliance easier (Fig. 4) . Remove the metal
grease filters , which are magnetically secured to
the appliance , by using either a hand tool or a kni-
fe edge. Act in the slot found in the filter sides, as
shown in
Fig. 10
. As an alternative, you can remove
the upper glass and push the filters from the inside
to outside. Fit the filters into their seat, by bringing
them close to the magnets until they keep them into
place . The charcoal filter is installed directly on the
grease filter rear side,
( see Fig.11)
. Charcoal filters
shall be replaced accordingly to the effective use of
the Downdraft, and in any case at least once every
6 months.
17 TRENTO