Ludlum Measurements 251450, Manual, Page: 11 / 82

Model 3030P Technical Manual
Section 2
Ludlum Measurements, Inc. Page 3 February 2021
Getting Started
Unpacking and Repacking
Remove the calibration certificate and place it in a secure location. Remove
the instrument and accessories (batteries, cable, etc.) and ensure that all of
the items listed on the packing list are in the carton. Check individual item
serial numbers and ensure calibration certificates match. The Model 3030P
serial number is located centered on the bottom of the back panel.
To return an instrument for repair or calibration, provide sufficient packing
material to prevent damage during shipment and ensure that any planchets
are removed from the sample counting tray and the sample holder/carrier is
either removed or secured with the set-screw provided. The aluminum
sample carrier in the sample drawer is secured in place for shipment using a
small set-screw, which can be removed using a 1/16 inch Allen wrench. It is
suggested that after the screw is removed, that the screw is re-secured in
place with a small amount of Loctite
®
thread locker, either using the Thread
locker SR Type 222 Purple®, or 222MS® (MIL-SPEC) MIL-S-46163A for
existing designs. ASTM D-5363**, NSF™ P1, CFIA (or equivalent).
Every returned instrument must be accompanied by an Instrument Return
Form, which can be downloaded from the Ludlum website at
www.ludlums.com . Find the form by clicking the “Support” tab and
selecting “Repair and Calibration” from the drop-down menu. Then choose
the appropriate Repair and Calibration division where you will find a link to
the form.
Software Installation
Interface software supplied with the instrument will need to be installed if
access to advanced features is desired. User must comply with the software
license agreement found in Section 7 of this manual
.
Install the Model 3030P interface software before making any connections
between the instrument and a computer.
Section
2