DO Commands and Administrative Tasks
Performing basic administration
MAX Administration Guide
2-3
Performing basic administration
The availability of a particular DO command depends on your location in the VT100 interface
and the Security profile in effect. DO commands are used for session management, call
management, and testing and troubleshooting. Commands for these functions are summarized
in Table 2-2 on page 2-4, Table 2-3 on page 2-6, and Table 2-4 on page 2-10.
Managing sessions
Besides aborting and exiting sessions (ESC DO 0 command), DO commands load parameter
values in the current profile, save the VT100 interface menu layout, log in or log out of the
unit, save the parameter values in a specified profile, and close an active Telnet session on the
unit.
Using the DO Load command
The DO Load command loads a saved or edited profile and overwrites the values of the current
profile. For example, suppose you have saved a profile named Memphis in the Directory
location 21-102 and your screen currently displays the following lines:
21-100 Directory
21-1 Factory
21-101 Tucson
>21-102 Memphis
If you execute DO Load, the following display appears:
Load profile...?
0=Esc (Don’t load)
1=Load profile 102
If you choose the first option by pressing 0 (zero), the MAX unit aborts the load operation. If
you choose the second option by pressing 1, the following status window appears:
Status #116
profile loaded
as current profile
The Directory menu shows the results of the load operation:
21-100 Directory
21-1** Memphis
21-101 Tucson
>21-102 Memphis
Saving the VT100 layout
The DO Menu Save command saves the entire current VT100 interface layout. The current
layout replaces the default layout.
Keep in mind the following additional information:
•
The DO Menu Save command appears only if the cursor is in front of the Sys Config
menu.
