3-4
Stinger®
IP2000 Configuration Guide
VLAN Configuration
Configuring a VLAN bridge circuit
Configuring DSL subscriber
bridging-options
settings
To pair a DSL interface with a VLAN ID, the connection or RADIUS profile must
enable bridging and specify the right ID for the destination VLAN. The far-end device
can be an IP router or a bridge. It is only within the Stinger unit that the VLAN ID is
inserted in the packet stream and the bridging occurs to the Gigabit Ethernet
interface.
For information about configuring a PVC to an IP router, see “Configuring IP
connection interfaces for CPE devices” on page 4-30. For information about ATM
PVCs, see the Stinger ATM Configuration Guide.
In addition to the usual settings, you must also specify the following parameters,
shown with default settings, in the DSL interface
connection
profile:
[in CONNECTION/"":bridging-options]
bridging-group = 0
bridge = no
dial-on-broadcast = no
Parameter
Setting
interface-address
Address of the Gigabit Ethernet port followed by the
VLAN ID, using the following format:
{ shelf-n slot-n port-n } vlan-id }
The
slot-n
is
8
(for the first control module) or
9
(the
second control module), and
port-n
is
2
for the Gigabit
port. The
vlan-id
value is the IEEE 802.1Q VLAN tag
value added to the IP packets transmitted on the Gigabit
Ethernet interface. The valid range is from 0 to 4095,
but for full compatibility with IEEE 802.1Q, Lucent
recommends that you do not use the
vlan-id
values of
0, 1 or 4095.
vlan-id
VLAN ID. This setting is read-only. You must set it in
the index of the
vlan-ethernet
profile.
enabled
Enable/disable the
vlan-ethernet
profile.
filter-name
Not used by the IP2000.
pppoe-options
Not used by the IP2000.
bridging-options:
bridging-group
A group number (from 0 to 65535) for the bridge circuit
between the VLAN and a WAN interface. The
bridging-
group
parameter in this profile must match the
bridging-group
parameter in the
connection
profile
that the
vlan-id
maps to.
bridging-options:
bridge
Enable/disable WAN packet bridging on the interface.
With WAN bridging, the system can provide a
connection between segments that are connected by a
telecommunications link. Set this parameter to
yes
to
enable WAN bridging.
dial-on-broadcast
Not used by the IP2000.
